CUT-THERM® is the quick modernisation solution system by EMPUR® that cuts a floor heating system into existing floors without causing damage or changing the screed level.
An experienced EMPUR® installation team uses a special floor milling machine to cut grooves for the heating pipes into the existing screed, with virtually no dust (cement or anhydride screed with a minimum thickness of 40 mm). Thus the floor lining can be placed into position immediately after the pipes have been laid into the grooves.
The grooves are cut directly into the existing screed! Thus the construction requirements are reduced to a minimum. No floor core refurbishment is required.
The CUT-THERM® installation teams carry out the following service:
Cutting of grooves into the existing screed at a laying distance of 12.5 cm
Laying of the floor heating pipes into the grooves
Installation of the heating circuit manifold and connecting of the floor heating pipes to the manifold
CUT-THERM® milling system
The EMPUR® milling system has many uses:
in new and old buildings
in residential and commercial buildings
in single family houses and buildings for multiple families
EMPUR® CUT-THERM® impresses with
Enabling the retrofitting of a floor heating system
No additional installation height (zero-installation-height)
Professional installation by our own staff
Minimal construction requirements - NO floor core refurbishment
Virtually dust-free cutting of the grooves
Quick laying and construction progress
e.g.: modernisation of a living space up to 120 square
Take two minutes...
...and we will demonstrate the laying of our CUT-THERM system to you!